Calibration Procedure
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
If the master brake cylinder has been replaced, verify that the correct pushrod is installed before attempting to calibrate the brake pedal position sensor.
- Turn ON the ignition, with the engine OFF.
- Install a scan tool, select the proper vehicle and options.
- Navigate to the BCM menu.
- Select Special Functions menu item.
- Select the BPPS sensor calibration procedure and follow the directions displayed on the screen.