Removal Procedure

NOTE: There are several types of plastic fuel and evaporative emission (EVAP) quick connect fittings used on this vehicle. The following instructions apply to all types of plastic quick connect fittings except where indicated.

Fig 1: Blowing Dirt Out Of Fitting (Plastic Collar)

Courtesy of GENERAL MOTORS CORP.

Relieve the fuel system pressure. Refer to Fuel Pressure Relief (Without CH 48027) or Fuel Pressure Relief (With CH 48027) .

WARNING: Wear safety glasses when using compressed air, as flying dirt particles may cause eye injury.

Use compressed air, blow and dirt or debris from around the quick-connect fitting.

Fig 2: View Of Quick Connect Fitting Release Tabs (Plastic Collar)

Courtesy of GENERAL MOTORS CORP.

Squeeze the plastic quick connect fitting release tabs together to disengage the quick connect fitting. (This step applies to Bartholomew style fittings ONLY).

Fig 3: Disengaging Quick Connect Fitting (Plastic Collar)

Courtesy of GENERAL MOTORS CORP.

Squeeze where indicated by the arrows on both sides of the plastic ring to disengage the quick connect fitting.

Fig 4: Disengaging Quick Connect Fitting (Plastic Collar)

Courtesy of GENERAL MOTORS CORP.

Squeeze where indicated by the arrows on both sides of the plastic ring to disengage the quick connect fitting.

Fig 5: Pulling Connection Apart (Plastic Collar)

Courtesy of GENERAL MOTORS CORP.

Pull the quick connect fitting connection apart.