LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 532 (Cruise Control System) >> Repair Instructions >> Cruise Control Release Switch Adjustment

Cruise Control Release Switch Adjustment

WARNING: This page is about a different car, the 2011 GMC Canyon and 2011 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Cruise Control Release Switch Electrical Connector
    GM1566570Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the cruise control release switch electrical connector (1).
    2. Fig 2: Identifying Cruise Release Switch
    GM1566571Courtesy of GENERAL MOTORS CORP.
  2. Rotate the cruise release switch counterclockwise, allowing the retainer to release.
  3. Pull the brake pedal rearward to full stop.
  4. While holding the brake pedal in position rearward, push the switch inward fully until the switch body contacts the brake pedal arm.

    At this point the plunger in the switch should be pushed in.

  5. Rotate the switch clockwise until a "click" is heard.
    6. Fig 3: Locating Cruise Control Release Switch Electrical Connector
    GM1566570Courtesy of GENERAL MOTORS CORP.
  6. Connect the cruise control release switch electrical connector (1).
  7. The switch is properly adjusted when there is 7 mm (0.28 in) clearance between the end of the barrel and the striker plate.
scientia non olet · About LEMON Manuals