Circuit/System Testing
- Ignition OFF. Disconnect the harness connector of the EBCM.
- Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 5 ohms between the ground circuit terminals listed below and ground:
- Terminal 16 (JL4)
- Terminal 26 (JM4)
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Verify that a test lamp illuminates between the B+ circuit terminals listed below and ground:
- Terminal 1 (JL4/JM4)
- Terminal 14 (JM4)
- Terminal 32 (JL4)
- If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
- If all circuits test normal, replace the EBCM.