LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Suspension >> Wheel Alignment System >> Repair Instructions >> Rear Camber Adjustment >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Control Arm & Stabilizer Shaft Link
    GM922511Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution
  1. Using a back-up wrench to prevent the link stud from rotating, install the stabilizer shaft links and link nuts and tighten to 60 N.m (44 lb ft) plus 30 degrees.
  2. Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals