Component Testing
- Disconnect the X1 harness connector at the turn signal/multifunction switch.
- Cruise control switch ON, measure the resistance between terminal 1 and terminal 5 while individually activating and holding each cruise control function switch and compare the resistance reading to the values in the table below.
- If not within the specified resistance range, replace the turn signal/multifunction switch.
| Function Switch | Minimum Resistance Value | Maximum Resistance Value |
|---|---|---|
| Off | O.L. | O.L. |
| On | 7.1k Ohms | 8.6k Ohms |
| - SET | 1.2k Ohms | 1.3k Ohms |
| + RES | 2.8k Ohms | 3.0k Ohms |