LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Uplander LT, 3.9 1 >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Immobilizer System >> Repair Instructions >> Theft Deterrent Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Theft Deterrent Control Module
    GM860152Courtesy of GENERAL MOTORS CORP.
  1. Push the TDM (2) onto the lock cylinder housing (1).
  2. Install the theft deterrent wiring harness to the steering column harness.
  3. Connect the electrical connector.
  4. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  5. Replace the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals