LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Optra LS, Standard >> Repair and Diagnosis >> Steering >> Power Steering >> Diagnostic Information and Procedures >> DTC 06 >> Test Description

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  This test checks for an open circuit or short to ground in the steering wheel position sensor circuits.
  2. 3:  This test checks for an open circuit or short to ground on the 5-volt reference circuit
  3. 4:  This test checks for a poor connection at the SSPS control module.
  4. 5:  This test checks for short to ground in the high actuator control circuits of the SSPS control module.
  5. 6:  This test checks for a poor connection at the power steering fluid flow control valve actuator.
Step Action Values Yes No
Schematic Reference:  Power Steering Schematics  
Connector End View Reference:  Component Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle
2 
  1. Disconnect the steering wheel position sensor.
  2. Turn ON the ignition with the engine OFF.
  3. Use a DMM to measure the voltage between the 5-volt reference circuit and the low reference circuit to the steering wheel position sensor. Refer to Circuit Testing .
Is the measured resistance within the specified value?
4.8-5.2 V Go to Step 5  Go to Step 3 
3  Test for an open or short to ground in the steering wheel position sensor 5-volt reference circuit. Refer to Testing for Continuity and Wiring Repairs .
Did you find and correct the condition?
- Go to Step 9  Go to Step 4 
4  Test for a poor connection at the speed sensitive power steering (SSPS) control module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?
- Go to Step 9  Go to Step 7 
5  Test for an open or short to ground in the steering wheel position sensor signal circuit. Refer to Testing for Continuity and Wiring Repairs .
Did you find and correct the condition?
- Go to Step 9  Go to Step 6 
6  Test for a poor connection at the steering wheel position sensor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?
- Go to Step 9  Go to Step 8 
7 Replace the power steering control module. Refer to Power Steering Control Module Replacement .
Is the repair complete?
- Go to Step 9  -
8 Replace the steering wheel position sensor. Refer to Steering Wheel Position Sensor Replacement .
Is the repair complete?
- Go to Step 9  -
9 Operate the system in order to verify the repair.
Did you correct the condition?
- System OK Go to Step 2