Test Description
The numbers below refer to the step numbers on the diagnostic table.
- 2: This test checks for an open circuit in the wiring and control valve actuator windings.
- 3: This test checks for a poor connection at the SSPS control module.
- 4: This test checks for an open in the low and high actuator control circuits of the SSPS control module.
- 5: This test checks for a poor connection at the power steering fluid flow control valve actuator.
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Power Steering Schematics Connector End View Reference: Component Connector End Views |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
7-17 Ω | Go to Step 3 | Go to Step 4 |
| 3 | Test for a poor connection at the SSPS control module. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
5.5-6.5 Ω | Go to Step 8 | Go to Step 5 |
| 4 |
|
- | Go to Step 8 | Go to Step 6 |
| 5 | Replace the SSPS control module control module. Refer to Power Steering Control Module Replacement . Is the repair complete? |
- | Go to Step 8 | - |
| 6 | Test for a poor connection at the power steering fluid flow control valve actuator. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
- | Go to Step 8 | Go to Step 7 |
| 7 | Replace the power steering fluid flow control valve actuator. Is the repair complete? |
- | Go to Step 8 | - |
| 8 | Operate the system in order to verify the repair. Did you correct the condition? |
- | System OK | Go to Step 2 |