LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Optra LS, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.0L (L34 GMDAT) - DTC P0016 To DTC P0317 >> DTC P0112 or P0113 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the IAT sensor.
  2. Ignition ON, clear the DTC information with a scan tool.
  3. Ignition OFF, test for less than 5 ohms of resistance between the low reference circuit terminal 1 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  4. Ignition ON, clear the DTC information with a scan tool.
  5. Ignition ON, verify the scan tool IAT sensor parameter is at -40°C (-40°F).
    • If greater than the specified range, test the signal circuit for a short to ground. If the circuit tests normal, replace the ECM.
  6. Install a 1A fused jumper wire between the signal circuit terminal 2 and the low reference circuit terminal 1. Verify the scan tool IAT sensor parameter is greater than 135°C (275°F).
      IMPORTANT: If the fuse in the jumper wire opens, the signal circuit is shorted to a voltage and the sensor may be damaged.
    • If less than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  7. If all circuits test normal, test or replace the IAT sensor.
scientia non olet · About LEMON Manuals