Installation Procedure

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Stabilizer Shaft Insulator Brackets, Bolts, and Insulators

Courtesy of GENERAL MOTORS CORP.

Using a pry bar, lift up on the stabilizer shaft and install the stabilizer shaft insulator.
Install the stabilizer shaft bracket.

NOTE: Refer to Fastener Notice .

Install the stabilizer shaft bracket bolts.
Tighten: Tighten the stabilizer shaft bracket bolts to 47 N.m (35 lb ft).
Lower the vehicle.