LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 301 (Engine Exhaust System) >> Repair Instructions >> Catalytic Converter Heat Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Catalytic Converter Heat Shield
    GM1553100Courtesy of GENERAL MOTORS CORP.
  1. Position the catalytic converter heat shield to the underbody.
  2. Install NEW catalytic converter heat shield rivets.
    3. Fig 2: Bank 2 Sensor 2 Electrical Harness Connector
    GM1553099Courtesy of GENERAL MOTORS CORP.
  3. Install the HO2S wiring harness from the clips on the catalytic converter heat shield.
  4. Install the catalytic converter. Refer to Catalytic Converter Replacement (RPOs LZE/LZ4/LZ9)  or Catalytic Converter Replacement (RPO LS4) .
scientia non olet · About LEMON Manuals