LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 259 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Bracket Replacement (RPO LS4) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator Bracket
    GM1552789Courtesy of GENERAL MOTORS CORP.
  1. Install the generator bracket to the stud.
    NOTE: Refer to Fastener Notice .
  2. Install the generator bracket bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  3. Raise the vehicle.
  4. Install the lower generator bracket bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  5. Install the lower tensioner bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  6. Lower the vehicle.
  7. Install the idler pulley. Refer to Drive Belt Idler Pulley Replacement .
  8. Install the generator. Refer to Generator Replacement (RPOs LZE/LZ4/LZ9)  or Generator Replacement (RPO LS4) .
scientia non olet · About LEMON Manuals