LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 1022 (Engine Exhaust System) >> Repair Instructions >> Exhaust Pipe Heat Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Exhaust Pipe Heat Shield
    GM1578494Courtesy of GENERAL MOTORS CORP.
  1. Position the exhaust pipe heat shield to the underbody.
    2. NOTE: Refer to Fastener Notice .
  2. Install the exhaust pipe heat shield nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  3. Install the exhaust heat shield. Refer to Exhaust Heat Shield Replacement (LE5) .
scientia non olet · About LEMON Manuals