LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Impala LTZ >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Repair Instructions >> Park Brake Support Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Parking Brake Components
    GM177182Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake shoe and actuator (4) onto the support (7).
  2. Position the park brake shoe, actuator (4), and support (7) over the rear hub.
  3. Install the park brake cable bracket (8) and the 2 retainers (9).
  4. Install the rear hub. Refer to Rear Wheel Bearing and Hub Replacement .

    The rear hub, support, park brake cable bracket, and park brake actuator will be installed as an assembly.

    5. Fig 2: View Of Rear Park Brake Cable & Wheel Speed Sensor Electrical Connector
    GM741967Courtesy of GENERAL MOTORS CORP.
  5. Install and connect the rear park brake cable to the bracket at the rear wheel. Refer to Parking Brake Rear Cable Replacement (Z7U) .
  6. Connect the park brake cable return spring to the park brake actuator and bracket at the rear wheel.
  7. Install the rear rotor. Refer to Rear Brake Rotor Replacement .
  8. Install the rear caliper bracket. Refer to Rear Brake Caliper Bracket Replacement .
  9. Install the rear wheels and tires. Refer to Tire and Wheel Removal and Installation .
  10. Adjust the park brake at the equalizer. Refer to Park Brake Adjustment .
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals