LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> HHR SS, Standard >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Vehicle Yaw Sensor with Vehicle Lateral Accelerometer Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Yaw Rate Sensor
    GM2017689Courtesy of GENERAL MOTORS CORP.
  1. Install the yaw rate sensor (1).
    2. NOTE: Refer to Fastener Notice .
    Fig 2: Yaw Rate Sensor Nuts
    GM2017685Courtesy of GENERAL MOTORS CORP.
  2. Install the yaw rate sensor nuts (1).

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  3. Connect the yaw rate sensor electrical connector.
  4. Carefully position the floor carpet to the vehicle floor.
  5. Install the right side body hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Right Side .
  6. Install the right front seat. Refer to Front Seat Replacement - Bucket .
  7. Install a scan tool.
  8. Using the special functions menu on the scan tool, reset the yaw rate sensor.
  9. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals