Circuit/System Testing
- Ignition ON, engine OFF. Disconnect the generator harness connector.
- Measure the voltage of the generator turn on signal circuit terminal 1. Verify the circuit has less than 1 volt.
- If greater than the specified value, test the generator turn on signal circuit for a short to voltage, or replace the ECM.
- Engine running. Measure the voltage of the generator turn on signal circuit terminal 1. Verify the circuit has greater than 3.5 volts.
- If less than 3.5 volts, test the generator turn on signal circuit for a short to ground, an open or a high resistance, or replace the ECM.
- Refer to Charging System Test .