LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Corvette Base, 2D Convertible, Standard >> Repair and Diagnosis >> Transmission >> Manual Transmission - TREMEC 6-Speed >> Repair Instructions - On Vehicle >> Shift Control Shift Closeout Boot Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Shift Control Closeout Boot & Nuts
    GM71523Courtesy of GENERAL MOTORS CORP.
  1. Install the shift control closeout boot.

    Check that the closeout boot fully seats to the shift control lever seal and the base of the shift control assembly (1).

    2. NOTE: Refer to Fastener Notice .
  2. Install the shift control closeout boot retaining nuts.

    Tighten:  Tighten the shift control closeout boot retaining nuts to 12 N.m (106 lb in).

    3. Fig 2: Shift Control Boot To Shift Control Lever
    GM71519Courtesy of GENERAL MOTORS CORP.
  3. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
  4. Install the shift control boot over the shift control lever.
    5. Fig 3: Shift Control Boot To I/P Accessory Trim Plate
    GM180589Courtesy of GENERAL MOTORS CORP.
  5. Align the shift control boot to the I/P accessory trim plate opening, then press to lock the boot retaining tabs.
  6. Adjust the shape of the boot for appearance, if necessary.
  7. Install the shift control knob. Refer to Transmission Control Lever Knob Replacement .
  8. Install the console. Refer to Console Replacement .
scientia non olet · About LEMON Manuals