LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Corvette Base, 2D Convertible, Standard >> Repair and Diagnosis >> Transmission >> Manual Transmission - TREMEC 6-Speed >> Repair Instructions - On Vehicle >> Shift Control Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Transmission Shift Rod, Clamp & Bolt
    GM71526Courtesy of GENERAL MOTORS CORP.
  1. Install the shift control assembly to the transmission shift rod clamp.
  2. Lower the shiftier into position and insert the locator into the shiftier bracket on the side of the driveline support assembly.
    3. NOTE: Refer to Fastener Notice .
  3. Install the shift control mounting bolts.

    Tighten:  Tighten the shift control mounting bolts to 30 N.m (22 lb ft).

  4. Install the transmission shift rod clamp bolt.

    Tighten:  Tighten the transmission shift rod clamp bolt to 30 N.m (22 lb ft).

    5. Fig 2: Releasing The Shift Control Neutral Lock Pin
    GM180816Courtesy of GENERAL MOTORS CORP.
  5. Lift to release the shift control neutral lock pin.
    6. Fig 3: Shift Control Closeout Boot & Nuts
    GM71523Courtesy of GENERAL MOTORS CORP.
  6. Install the shift control closeout boot.

    Check that the closeout boot fully seats to the shift control lever seal and the base of the shift control assembly (1).

  7. Install the shift control closeout boot retaining nuts.

    Tighten:  Tighten the shift control closeout boot retaining nuts to 12 N.m (106 lb in).

  8. Install the acoustic boot.
    9. Fig 4: Shift Control Boot To Shift Control Lever
    GM71519Courtesy of GENERAL MOTORS CORP.
  9. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
  10. Install the shift control boot over the shift control lever.
    11. Fig 5: Shift Control Boot To I/P Accessory Trim Plate
    GM180589Courtesy of GENERAL MOTORS CORP.
  11. Align the shift control boot to the I/P accessory trim plate opening, then press to lock the boot retaining tabs.
  12. Adjust the shape of the boot for appearance, if necessary.
  13. Install the shift control knob. Refer to Transmission Control Lever Knob Replacement .
  14. Install the console. Refer to Console Replacement .
scientia non olet · About LEMON Manuals