LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Corvette Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Replacement (LZ4) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Wiring Harness Electrical Connector
    GM1777669Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the drive belt. Refer to Drive Belt Replacement .
  3. Disconnect the engine wiring harness electrical connector (3).
  4. Reposition the engine wiring harness terminal boot (4).
  5. Remove the engine wiring harness terminal lead to generator nut (1).
  6. Remove the engine wiring harness terminal (2) from the generator stud.
    7. Fig 2: View Of Power Steering Pump
    GM1777755Courtesy of GENERAL MOTORS CORP.
  7. Remove the power steering line clip nut (1).
  8. Remove the power steering line clip (2) from the generator stud and reposition the lines out of the way.
    9. Fig 3: View Of Generator Rear Brace Upper Nut
    GM1775001Courtesy of GENERAL MOTORS CORP.
  9. Remove the generator through bolt (3).
    10. Fig 4: View Of Generator
    GM1784880Courtesy of GENERAL MOTORS CORP.
  10. Remove the generator side bolt and stud.
  11. Remove the generator.
scientia non olet · About LEMON Manuals