LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Corvette Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Tray Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Battery Positive Cable, Cable Clips, Bolts & Nuts
    GM1783030Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine control module (ECM). Refer to one of the following:
  2. Remove the battery. Refer to Battery Replacement .
  3. Loosen the positive battery cable bolt (6) at the junction block and remove the cable from the junction block.
    4. Fig 2: Identifying Junction Block Assembly
    GM1783957Courtesy of GENERAL MOTORS CORP.
  4. Remove the junction block cover (1).
  5. Loosen the junction block bolts (2) and remove the junction block.
  6. Remove the body wiring harness electrical connectors (3) from the battery tray.
  7. Remove the forward lamp wiring harness electrical connector (4) and the engine wiring harness electrical connector (5) from the battery tray.
    8. Fig 3: View Of Battery Tray
    GM1783863Courtesy of GENERAL MOTORS CORP.
  8. Remove the battery tray bolts and nut.
  9. Remove the air duct from the battery tray.
  10. Remove the battery tray.
    11. Fig 4: View Of Battery Tray Support
    GM1459608Courtesy of GENERAL MOTORS CORP.
  11. If necessary, remove the battery tray support bolts (2) and stud (1).
  12. Remove the battery tray support (3).
scientia non olet · About LEMON Manuals