LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Corvette Base, 2D Convertible, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Diagnostic Information and Procedures >> Cruise Control Malfunction >> Circuit/System Testing

Circuit/System Testing

IMPORTANT: Inspect for proper operation of the clutch pedal position (CPP) sensor. Do not perform this diagnostic if DTC P0806, P0807, P0808 or P080A are stored in the ECM. Refer to DTC P0806 , DTC P0807 or P0808 or DTC P080A , if this DTC is set in the ECM as current or history.
  1. Disconnect the harness connector X1 at the multifunction switch.
  2. Ignition ON, test for greater than 10 volts between the supply voltage circuit terminal 1 and ground.
    • If less than the specified range, test the supply voltage circuit for a short to ground or an open/high resistance.
  3. Ignition ON, test for 0.0 volts between the cruise control switch signal circuit terminal 5 and ground.
    • If greater than the specified value, test the signal circuit terminal 5 for a short to voltage. If the circuit tests normal, replace the BCM.
  4. Ignition OFF, connect the harness connector X2 at the multifunction switch.
  5. Ignition ON, with the cruise control switch in the ON position, observe the scan tool Cruise Control Switch parameter. The parameter should display ON.
    • If not the specified value, test the signal circuit terminal 5 for a short to ground or an open/high resistance. If the circuit tests normal, test or replace the multifunction switch.
  6. Observe the scan tool Cruise Control Switch parameter while pressing the RES + portion of the cruise control switch. The parameter should display Resume.
    • If not the specified value, test or replace the multifunction switch.
  7. Observe the scan tool Cruise Control Switch parameter while pressing the SET - portion of the cruise control switch. The parameter should display Set.
    • If not the specified value, test or replace multifunction switch.
  8. If the circuits test normal, test or replace the ECM.
scientia non olet · About LEMON Manuals