LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pump Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Power Steering Pump Rear Bracket, Power Steering Pump & Mounting Bolts
    GM663512Courtesy of GENERAL MOTORS CORP.
  1. Install the following components to the power steering pump rear bracket (1):
    • The power steering pump (2)
    • The power steering pump front bracket (3)
    2. NOTE: Refer to Fastener Notice .
  2. Install the power steering pump mounting bolts (4) to the power steering pump (2).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  3. Install the power steering reservoir outlet pipe/hose to the power steering pump. Refer to Power Steering Fluid Reservoir Outlet Hose Replacement .
  4. Install the power steering pressure hose to the power steering pump. Refer to Power Steering Pressure Pipe/Hose Replacement .
  5. Install the power steering pump pulley. Refer to Power Steering Pump Pulley Replacement .
  6. Install the power steering fluid reservoir. Refer to Remote Power Steering Fluid Reservoir Replacement .
  7. Install the BPMV bracket. Refer to Brake Pressure Modulator Valve Bracket Replacement .
  8. Install the BPMV. Refer to Brake Pressure Modulator Valve Replacement .
  9. Bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals