LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Cobalt SS >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Starter Motor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Starter Bolts & Starter
    GM1648192Courtesy of GENERAL MOTORS CORP.
  1. Position the starter to the engine.
    2. NOTE: Refer to Fastener Notice .
  2. Install the starter bolts.

    Tighten:  Tighten the bolts to 40 N.m (30 lb ft).

    3. Fig 2: View Of Engine Harness Terminal To Starter
    GM1656131Courtesy of GENERAL MOTORS CORP.
  3. Install the engine harness terminal (1) to the starter.
  4. Install the starter solenoid "S" terminal nut (2).

    Tighten:  Tighten the nut to 3 N.m (27 lb in).

  5. Install the starter solenoid wire terminal (3) to the starter.
  6. Install the positive battery cable terminal (4) to the starter. Ensure that the anti-rotational tab is correctly located into the indexing slot.
  7. Install the starter solenoid terminal nut (5).

    Tighten:  Tighten the nut to 17 N.m (13 lb ft).

  8. Lower the vehicle.
  9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals