LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Chevy Express G3500, Van Passenger Extended >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Electronic Brake Control Module Replacement (w/JL4) >> Installation Procedure

Installation Procedure

    Fig 1: Brake Pressure Modulator Valve & Electronic Brake Control Module
    GM1381552Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not use room temperature vulcanizing (RTV) or any other type of sealant on the EBCM gasket or mating surfaces.
  1. Install the EBCM (2) on to the BPMV (1).
    2. NOTE: Refer to Fastener Notice .
  2. Install the screws to the EBCM (2).

    Tighten:  Tighten the screws to 5 N.m (44 lb in) in an X-pattern.

    3. Fig 2: Identifying Chassis Electrical Connectors To EBCM
    GM924296Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connectors to the EBCM.
    4. Fig 3: Splash Shield (Cutaway Vehicles)
    GM1209085Courtesy of GENERAL MOTORS CORP.
  4. For cutaway vehicles, install the splash shield.

    Tighten:  Tighten the splash shield bolts to 25 N.m (18 lb ft).

  5. Lower the vehicle.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  7. Revise the tire calibration using the Tire Size Calibration function.
  8. Verify correct system operation. Refer to Diagnostic Starting Point - Antilock Brake System .
  9. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals