LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Chevy Express G2500, Van Passenger >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Diagnostic Information and Procedures >> DTC C0292 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the yaw rate and lateral accelerometer sensor connector X318.
  2. Ignition OFF, test for less than 1 ohm of resistance between the low reference circuit Connector X318, terminal C6 and ground.
    • If greater than 1 ohm, test the low reference circuit and the EBCM ground circuits terminals 11 and 28 for a short to voltage or an open/high resistance. If the circuits test normal, replace the EBCM.
  3. Test the lateral accelerometer signal circuits Connector X318, terminal A6 and A5 the 5-volt reference circuit terminal B6, and the low reference circuit terminal C6 for an open/high resistance or a short to voltage or ground.
    • If all circuits test normal, replace the yaw rate sensor and lateral accelerometer sensor, and perform the yaw rate reference table resetting in the EBCM.
    • If the DTC sets again after replacing the yaw rate sensor and lateral accelerometer sensor, replace the EBCM.
scientia non olet · About LEMON Manuals