Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Install the rear run channel (1) to the door.
- Install the bolt (2) in order to retain the rear run channel (1) to the door.
Tighten: Tighten the retaining bolt to 11 N.m (97 lb in).
- Install the front door window to the door from the outside of the vehicle.
- Install the nuts (3) in order to retain the front door window to the sash.
Tighten: Tighten the retaining nuts to 11 N.m (97 lb in).
- Note
Lower the front door window.
- Install the front run channel (1) to the door.
- Install the bolt (2) in order to retain the front run channel (1) to the door.
Tighten: Tighten the retaining bolt to 11 N.m (97 lb in).
- Adjust window channel for proper alignment.
- Install the inner window sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement .
- Install the outer window sealing strip. Refer to Outer Belt Sealing Strip Replacement .
- Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
- Install the front door rear garnish. Refer to Front Side Door Rear Garnish Molding Replacement .
- Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
CAUTION:
Refer to Fastener Caution
.