LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Uplander Base, 3.9 W >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Rear Suspension System) >> Repair Instructions >> Trailing Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the trailing arm (3) to the trailing arm bracket.
    Fig 1: Exploded View Of Rear Suspension
    GM1210232Courtesy of GENERAL MOTORS CORP.
  2. Install the bolt (7) and nut (4) to the trailing arm (3) and the trailing arm bracket.

    Tighten:  Tighten the bolt and nut to 105 N.m (77 lb ft).

    NOTE: Refer to Fastener Notice .
  3. Install the trailing arm (3) to the knuckle (8).
  4. Install the bolt (6) and nut (2) to the trailing arm (3) and the knuckle (8).

    Tighten:  Tighten the nut to 240 N.m (177 lb ft).

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals