LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Uplander Base, 3.9 1 >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Hydraulic Brake System) >> Repair Instructions >> Master Cylinder Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Bench bleed the master cylinder. Refer to Master Cylinder Bench Bleeding .
    Fig 1: View Of Master Cylinder
    GM177372Courtesy of GENERAL MOTORS CORP.
  2. Install the master cylinder to the vacuum brake booster.
  3. Install the master cylinder mounting nuts.

    Tighten:  Tighten the master cylinder mounting nuts to 33 N.m (24 lb ft).

    NOTE: Refer to Fastener Notice .
  4. Remove the plugs from the brake pipes
  5. Connect the brake pipes to the master cylinder.

    Tighten:  Tighten the brake pipe fittings at the master cylinder to 18 N.m (13 lb ft).

  6. Connect the electrical connector to the brake fluid level sensor.
  7. Bleed the brake system. Refer to Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure) .
scientia non olet · About LEMON Manuals