Installation Procedure

Fig 1: ECM/TCM Bracket Retaining Bolts

Courtesy of GENERAL MOTORS CORP.

If the ECM/TCM bracket (1) was previously removed, install the ECM/TCM bracket (1) to the vehicle frame.
Install the ECM/TCM bracket retaining bolts (2).

NOTE: Refer to Fastener Notice .

Tighten the ECM/TCM bracket bolts.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
Install the TCM. Refer to Transmission Control Module Replacement .

Fig 2: Identifying ECM/TCM Bracket Upper Retainers

Courtesy of GENERAL MOTORS CORP.

Insert the ECM into the retaining slots of the ECM/TCM bracket.
Secure the ECM to the bracket ensuring that the ECM retaining tabs (1) are fully engaged.

Fig 3: View Of ECM

Courtesy of GENERAL MOTORS CORP.

Fig 4: View Of ECM/TCM & Cover

Courtesy of GENERAL MOTORS CORP.

Install the ECM/TCM cover.
Ensure the ECM/TCM cover retainers (1) are fully engaged to the ECM/TCM bracket.
Connect the cooling fan electrical connector.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
If the ECM was replaced the replacement ECM must be programmed. Refer to Control Module References .