Removal Procedure

IMPORTANT: Do NOT swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock®, and "XM Theftlock®" will display.

Remove the right side junction block from the instrument panel (I/P). Refer to Instrument Panel Electrical Center or Junction Block Replacement - Right Side .
Do not disconnect the electrical connectors.
Lower the I/P compartment door to the full open position.
From the junction block opening, remove the 2 retaining screws (1).
Pull the receiver and bracket assembly from the I/P compartment opening.

Fig 1: View Of Digital Radio Receiver & Wire Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the wire connector.
Disconnect the coaxial cable from the receiver.
Remove the receiver and bracket assembly from the I/P.