LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Column Trim Covers Replacement >> Installation Procedure

Installation Procedure

  1. Position the upper steering column cover and the lower steering column cover together on the steering column.
    Fig 1: View Of Upper & Lower Steering Column Cover & Steering Column
    GM1837590Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Make sure that the tabs from the upper steering column cover line up to the lower steering column cover and engage properly.
  2. Install the 2 retaining screws to the lower steering column trim cover.

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

    Fig 2: View Of Lower Steering Column Trim Cover & Retaining Screws
    GM1837562Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the tilt lever.
    Fig 3: View Of Tilt Lever
    GM1837542Courtesy of GENERAL MOTORS CORP.
  4. Install the steering column filler. Refer to Steering Column Opening Filler Replacement .
  5. Install the steering wheel. Refer to Steering Wheel Replacement .
  6. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (RPO LS4) or Battery Negative Cable Disconnection and Connection (RPOs LZE/LZ4/LZ9) .
  7. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals