LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Intermediate Steering Shaft Replacement >> Installation Procedure

Installation Procedure

  1. Position the intermediate steering shaft into place.
    Fig 1: View Of Upper Pinch Bolt Of Intermediate Steering Shaft
    GM454259Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .

    Install the upper pinch bolt which secures the intermediate steering shaft to the steering column.

    Tighten:  Tighten the pinch bolt to 62 N.m (46 lb ft).

  2. Install the intermediate steering shaft seal onto the steering column.
    Fig 2: View Of Intermediate Steering Shaft To Power Steering Gear Stub Shaft
    GM294371Courtesy of GENERAL MOTORS CORP.
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Install the intermediate steering shaft (1) to the power steering gear stub shaft (2).
  5. Install the lower pinch bolt which secures the intermediate steering shaft to the power steering gear stub shaft.

    Tighten:  Tighten the pinch bolt to 48 N.m (35 lb ft).

  6. Remove the J 42640  from the steering column.
    Fig 3: Identifying J 42640
    GM333146Courtesy of GENERAL MOTORS CORP.
  7. Install the intermediate steering shaft seal onto the power steering gear.
    Fig 4: Providing Access To Intermediate Steering Shaft Lower Pinch Bolt
    GM294376Courtesy of GENERAL MOTORS CORP.
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  9. Lower the vehicle.
  10. Install the left closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
scientia non olet · About LEMON Manuals