LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 978 (Engine Controls And Fuel - 3.5L - Repair Instructions) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disconnecting/Connecting Camshaft Position (CMP) Sensor Electrical Connector
    GM1599076Courtesy of GENERAL MOTORS CORP.
  1. Replace the O-ring seal if damaged, lubricate the NEW O-ring with clean engine oil.
  2. Install the CMP sensor.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: View Of Fuel Injector Wiring Harness Electrical Connector
    GM1775160Courtesy of GENERAL MOTORS CORP.
  4. Connect the fuel injector wiring harness electrical connector to the CMP sensor.
  5. Install the power steering pump, if required. Refer to Power Steering Pump Replacement (LZ4) .
  6. Install the intake manifold cover. if required. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals