LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 945 (Power Steering System) >> Repair Instructions >> Steering Gear Boot Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new clamp loosely on the inner part of the steering gear boot.
    2. Fig 1: View Of Steering Gear Boot
    GM854991Courtesy of GENERAL MOTORS CORP.
  2. Apply grease from the service kit to the indicated locations.
    3. IMPORTANT: The steering gear boot must seat in the appropriate groove on the steering gear.
  3. Install the steering gear boot over the steering gear inner tie rod and onto the steering gear.
  4. Using pliers J 22610  , crimp the inner steering gear boot clamp.
  5. Install the outer steering gear boot clamp.
  6. Install a new steering gear inner tie rod nut in the same position the prior one was removed from.
    7. Fig 2: View Of Outer & Inner Tie Rods
    GM854987Courtesy of GENERAL MOTORS CORP.
  7. Install the rack and pinion outer tie rod end. Refer to Steering Linkage Outer Tie Rod Replacement .
  8. Adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .
scientia non olet · About LEMON Manuals