LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 866 (Rear Suspension System) >> Repair Instructions >> Shock Absorber Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Shock Absorber
    GM2013878Courtesy of GENERAL MOTORS CORP.
  1. Position the shock absorber (1) in the vehicle.
    2. Fig 2: Identifying Upper Shock Absorber Mounting Bolts
    GM2013803Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the upper shock absorber nuts (1).

    Tighten:  Tighten the upper mounting nuts (1) to 25 N.m (18 lb ft).

    3. Fig 3: View Of Lower Shock Absorber Bolt & Washer
    GM2013772Courtesy of GENERAL MOTORS CORP.
  3. Install the lower shock absorber bolt (3) and the washer (2) in the knuckle (1).,

    Tighten:  Tighten the lower mounting bolt (3) to 180 N.m (133 lb ft).

  4. Remove the jack stand from the knuckle.
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals