Brake Pedal Position Sensor Replacement

WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Brake Pedal Position Sensor & Bolt

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the instrument panel insulator panel. Refer to Instrument Panel Insulator Replacement - Left Side . Remove the intermediate steering shaft bolt and position the intermediate steering shaft away from the steering column in order to gain access to the brake pedal adjustment position sensor. Refer to Intermediate Steering Shaft Replacement .
1	Brake Pedal Position Sensor Bolt NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
2	Brake Pedal Position Sensor Procedure: Disconnect the electrical connector.

Callout

Component Name

Preliminary Procedures

Remove the instrument panel insulator panel. Refer to Instrument Panel Insulator Replacement - Left Side .
Remove the intermediate steering shaft bolt and position the intermediate steering shaft away from the steering column in order to gain access to the brake pedal adjustment position sensor. Refer to Intermediate Steering Shaft Replacement .

Brake Pedal Position Sensor Bolt

NOTE: Refer to Fastener Notice .

Tighten: 2 N.m (18 lb in)

Brake Pedal Position Sensor
Procedure:
Disconnect the electrical connector.