Left SOD Indicator Malfunction
WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the X2 harness connector at the driver outside rearview mirror.
- Ignition OFF, test for less than 1.0 ohm between the low reference circuit terminal 1 and ground.
- If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the driver door module
- Ignition ON, command the left side blind zone indicator ON with the scan tool. Test for greater than 2.5 volts between the control circuit terminal 4 and ground.
- If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the driver door module.
- If all circuits test normal, replace the driver outside rearview mirror.