LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 770 (Object Detection System) >> Diagnostic Information and Procedures >> DTC B356A >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Before disconnecting the harness connector at the VDAAW module, ensure that the ignition has been OFF for at least 120 seconds. Failure to do so may result in component damage.
  1. Ignition OFF for 120 seconds, disconnect the harness connector at the headlamp switch.
  2. Ignition ON, verify the scan tool Mode Switch parameter is Inactive.
    • If not the specified value, test the signal circuit terminal 9 for a short to ground. If the circuit tests normal, replace the VDAAW module.
  3. Install 3A fused jumper wire between the signal circuit terminal 9 and ground. Verify the scan tool Mode Switch parameter is Active.
    • If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the VDAAW module.
  4. If all circuits test normal, test or replace the headlamp switch.
scientia non olet · About LEMON Manuals