Installation Procedure

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Shock Absorber

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the shock, reinforcement, and the retaining nuts.
Tighten: Tighten the upper shock absorber retaining nuts to 25 N.m (18 lb ft).

Fig 2: Identifying Shock Absorber Upper Retaining Bolts

Courtesy of GENERAL MOTORS CORP.

Install the upper shock absorber cover.
Install the trunk trim.

Fig 3: Identifying Shock Absorber Lower Retaining Bolts

Courtesy of GENERAL MOTORS CORP.

Install the lower shock absorber retaining bolts.
Tighten: Tighten the lower shock absorber retaining bolts to 25 N.m (18 lb ft).
Connect the automatic level control air tube to the shock.
Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.