LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 599 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Stabilizer Shaft
    GM160493Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft (4) to the vehicle.
  2. Install the stabilizer shaft insulators to the stabilizer shaft with the slits forward.
  3. Bend the stabilizer shaft insulator brackets downward.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the stabilizer shaft bracket retaining bolt.

    Tighten:  Tighten the stabilizer shaft bracket retaining bolts to 33 N.m (24 lb ft).

  5. Install the stabilizer shaft links. Refer to Stabilizer Shaft Link Replacement .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals