LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 582 (Cellular System, Entertainment System, And Navigation System) >> Repair Instructions >> Antenna Replacement - Cellular Communications/Digital Radio >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Antenna Assembly
    GM1491976Courtesy of GENERAL MOTORS CORP.
  1. Install the antenna mast to the antenna base.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the antenna mast screws.

    Tighten:  Tighten the screws to 1 N.m (9 lb in).

  4. Position the digital radio antenna to the roof.
  5. Fig 2: View of Digital Radio Antenna Connectors, Bolt, Expansion Sleeve, and Retainer
    GM863301Courtesy of GENERAL MOTORS CORP.
  6. Route the wiring pigtail to the side in the slot on the antenna shaft and install the antenna expansion sleeve (3) and bolt (2) to the antenna shaft.

    Tighten:  Tighten the bolt to 6 N.m (53 lb in).

  7. Connect the antenna connectors (1).
  8. Wrap the connectors (1) with foam tape.
  9. Install the antenna cable connection above the AM/FM antenna module.
  10. Install the antenna cable hold down clips.
  11. Align the headliner to the roof panel.
  12. Install the rear assist handles. Refer to Assist Handle Replacement in Interior Trim.
  13. Install the upper rear quarter trim panel. Refer to Rear Quarter Upper Trim Panel Replacement in Interior Trim.