LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 507 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC B1019 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2007 Saturn Sky. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, use the scan tool to request SIR DTCs. Verify that DTC B1019 is set as current.
    • If DTC B1019 is history, clear codes and recheck.
  2. Using the scan tool check the BCM that is programmed with the VIN. Verify that the BCM is programmed with the correct VIN number with the vehicle VIN plate.
  3. Using the scan tool perform the Setup SDM Part Number into BCM procedure. Refer to Control Module References for programming.
  4. Ignition ON, use the scan tool to clear the DTCs then cycle the ignition OFF then back ON. Verify that DTC B1019 is cleared.
    • If DTC B1019 was current replace the SDM.
scientia non olet · About LEMON Manuals