Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Install the following components to the washer solvent container:
- The washer pump assembly and seal. Refer to Washer Pump Replacement .
- The washer level sensor and seal. Refer to Washer Solvent Container Level Sensor Replacement .
- The solvent container cap
- The solvent container hose. Refer to Washer Solvent Container Hose Replacement .

Fig 1: View Of Washer Level Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Position the washer solvent container to the left frame rail.
Install the washer solvent container nuts.
Tighten: Tighten the screw to 10 N.m (89 lb in).
Connect the washer pump electrical connector.
Connect the washer level sensor electrical connector.
Install the front fender liner. Refer to Front Fender Liner Replacement .
Fill the washer solvent container with washer solvent.

Fig 2: View Of Solvent Container Washer Hose

Courtesy of GENERAL MOTORS CORP.

Connect the washer solvent container hose to the windshield washer hose.
Close the hood.
Inspect the washers for proper operation.