LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 250 (Door System, Mirror System & Window System) >> Repair Instructions >> Front Door Window Regulator Motor Replacement

Front Door Window Regulator Motor Replacement

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Replacing Front Door Window Regulator Motor
GM1589807Courtesy of GENERAL MOTORS CORP.
Window Regulator Motor Replacement - Front Door

Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .

Preliminary Procedures

  1. Position window approximately half way down in the door.
  2. Remove the interior trim panel. Refer to Trim Panel Replacement - Side Front Door (Impala) .
  3. Remove the water deflector. Refer to Water Deflector Replacement - Front Door (Impala)  or Water Deflector Replacement - Front Door (Monte Carlo) .
  4. Tape the window to door frame to prevent it from moving.
  5. Remove the front door window regulator. Refer to Window Replacement - Front Door (Impala)  or Window Replacement - Front Door (Monte Carlo) .
1 Screw, Front Side Door Window Regulator Motor (Qty: 3)

Tighten:  4.6 N.m (41 lb in)
2 Motor, Front Side Door Window Regulator
Tip:  Disconnect the electrical connector from the window regulator motor.
scientia non olet · About LEMON Manuals