LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Lighting Systems) >> Diagnostic Information and Procedures >> Turn Signal Lamps and/or Indicators Malfunction >> Circuit/System Testing >> Turn Signal/Multifunction Switch Circuit Malfunction

Turn Signal/Multifunction Switch Circuit Malfunction

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector C1 at the turn signal/multifunction switch.
  2. Test for less than 1.0 ohm of resistance between the ground circuit terminal E and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify the scan tool Left Turn Signal Switch parameter is Inactive.
    • If not the specified value, test the signal circuit terminal D for a short to ground. If the circuit tests normal, replace the BCM.
  4. Verify the scan tool Right Turn Signal Switch parameter is Inactive.
    • If not the specified value, test the signal circuit terminal F for a short to ground. If the circuit tests normal, replace the BCM.
  5. Install a 3A fused jumper wire between the signal circuit terminal D and the ground circuit terminal E. Verify the scan tool Left Turn Signal Switch parameter is Active.
    • If not the specified value, test the signal circuit for a short to voltage or and open/high resistance. If the circuit tests normal, replace the BCM.
  6. Install a 3A fused jumper wire between the signal circuit terminal F and the ground circuit terminal E. Verify the scan tool Right Turn Signal Switch parameter is Active.
    • If not the specified value, test the signal circuit for a short to voltage or and open/high resistance. If the circuit tests normal, replace the BCM.
  7. If all circuits test normal, test or replace the turn signal/multifunction switch.