LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 216 (Antilock Brake System With Traction Control System & Stability Control System) >> Repair Instructions >> ABS Automated Bleed Procedure >> Automated Bleed Procedure >> Preliminary Setup

Preliminary Setup

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and vehicle on a suitable support. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Turn the ignition switch to OFF position.
  3. Remove all 4 tires, if necessary. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Connect the pressure bleeding tool according to the manufacturer's instructions.
  5. Turn the ignition switch to RUN position, engine off.
  6. Connect a scan tool and establish communications with the ABS system.
  7. Pressurize the bleeding tool to 206-241 kPa (30-35 psi).
scientia non olet · About LEMON Manuals