Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Radio Wiring Harness

Courtesy of GENERAL MOTORS CORP.

Install the XM digital radio receiver to the receiver bracket.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the radio receiver nuts.
Tighten: Tighten the nuts to 4 N.m (35 lb in).

Fig 2: Identifying XM Digital Radio Receiver

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors and the antenna connectors to the XM radio receiver.

Fig 3: View Of Knee Bolster Assembly

Courtesy of GENERAL MOTORS CORP.

Install the left I/P insulator. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel in Instrument Panel, Gages and Console.
Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Programming and Setup .