Radio Replacement

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Replacing Radio

Courtesy of GENERAL MOTORS CORP.

Radio Replacement

Callout	Component Name
NOTE: Refer to Fastener Notice in Cautions and Notices. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
Radio Assembly Replacement
1	Panel, I/P Accessory Trim
2	Screw, Radio Assembly (Qty: 4) Tighten: 2 N.m (18 lb in)
3	Radio Assembly Tip: Loosen the HVAC control enough to let the radio clear the I/P. Disconnect the antenna cable. Disconnect the electrical connector. Perform the radio setup procedure when replacement is complete. Refer to Radio Setup .