LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 5.3L - DTC P0016 To DTC P0442 >> DTC P0351-P0358 >> Circuit/System Testing

Circuit/System Testing

  1. Turn OFF the ignition.
  2. Disconnect the ECM C2 harness connector.
    3. IMPORTANT: A high resistance on any IC circuit can cause a misfire before the DTC sets.
  3. Test the affected IC circuit for the following:
    • Short to voltage
    • Short to ground
    • Open/high resistance
    • If a fault is found, repair the circuit as needed.
  4. Connect the ECM C2 harness connector.
  5. Exchange the affected ignition coil/module, with the ignition coil/module of a cylinder that is not affected.
  6. Start the engine and observe the scan tool.
    • If the DTC or the misfire transfers with the suspect ignition coil/module, replace that ignition coil/module assembly.
    • If the DTC or the misfire does not transfer with the suspect ignition coil/module, replace the ECM.
scientia non olet · About LEMON Manuals